How to Adjust Vibration Parameters on a Dual Servo Block Machine When Changing Product Types
Changing product types is routine in a block plant. When solid bricks are switched to hollow blocks, or hollow blocks to paving bricks, the mold is replaced but the vibration parameters often stay as they were. This is a situation that commonly arises after a fixed-frequency vibration block machine has been in use for some time. The vibration source on conventional machines is an asynchronous motor driving an eccentric block through a belt pulley. Frequency and amplitude are fixed at the factory, and when product types change, the only adjustment available is usually the vibration duration, which has limited range. What dual servo block machines change at this stage is not an added function but the conversion of vibration from an on-off action into one that can be continuously adjusted in both frequency and amplitude.
What Vibration Adjustment Covers When Changing Product Types
Publicly available machine specifications show that some dual servo models specify amplitude control accuracy of ±0.1 mm, with frequency adjustable between 20 Hz and 60 Hz, and parameters can be matched to the material composition. The significance of this range is not the numbers themselves but the fact that operators have more to adjust when changing product types. Solid bricks use medium frequency and relatively short vibration time. Hollow blocks require the aggregate around the core to be compacted, so the time is extended. Pervious bricks have coarse aggregate, so the frequency is raised. Thick products such as curbstones require vibration time to be set in a longer range. When fixed-frequency machines switch among these product types, compaction on one side is often sacrificed. The adjustability of servo vibration widens the process window to some extent, allowing each product type to have a relatively suitable vibration range. Specific seconds should be based on the machine manual and on-shift trials, and the setting for one product type should not be directly applied to another.
What the Hydraulic Side Saves Is the Idling Portion
In conventional systems, the oil pump motor is sized according to peak pressure and flow and runs at constant speed, with excess oil returning through the relief valve and turning into heat. The difference with servo hydraulics is that the motor only delivers power when an action is required. During clamping and pressure holding, the speed drops close to zero while output pressure is maintained at the required value. Some publicly available technical materials describe this change as relatively fast starting and stopping response, with unit energy consumption lower than conventional equipment. Other publicly available comparative data mention that a certain type of dual servo model reduces energy consumption by about 20% compared with conventional processes and reduces overall production cost by about 15%. These figures have test preconditions and should not be directly applied to every machine, but the direction is clear: the energy saved by the servo system mainly comes from no longer idling when no action is needed.
Mold Change Time Affects Production Scheduling
One detail that is easily overlooked is mold change time. Publicly available model information mentions that a modular structure can keep mold change time within 15 minutes. For block plants handling multiple product types and small batch orders, mold change speed directly affects how many product types can be scheduled in a day. The servo system itself does not determine mold change speed, but when a modular frame and programmable switching of servo control are combined, changing product types shifts from a long shutdown and debugging process to a routine operation that can be arranged by shift. When scheduling production, mold change time and vibration parameter debugging time should be counted together, and daily capacity should not be estimated from the molding cycle alone.
The Standards Framework Has No Separate Category
At the standards level, there is no separate category for the dual servo block machine. It still falls within the framework of GB/T 8533—2008 Small Block Forming Machines and GB/T 36515—2018 Concrete Products Machinery Safety Requirements for Block Forming Machines. Servo changes the drive mode and adjustment method, but it does not change the basic aspects of the forming process and safety constraints. Stating this clearly is closer to reality than describing dual servo as an independent equipment category.
Suggestion & Feedback:qzhy@qzhy.cn