1. Inconsistent density of bricks before and after: Adjust the feeding parameters of the cement brick machine.

        2. Inconsistent height of bricks: Replace the vibration table or pressure head rubber pad of the cement brick machine, and adjust the height of the round nut.

        3. Defective blocks: adjust the feeding time of the material cart and replenish materials in a timely manner.

        4. Unstable lowering speed of the main cylinder: replace the sealing ring of the main cylinder or the valve body of the electromagnetic directional valve.

        5. The alternating impact between automatic cards and slow speed is very significant: the interval between automatic cards and the Shanghai Composite Index should not be less than 1 to restore.

        6. At the moment of pressing the brick, the axle and transmission shaft vibrate: change the direction of the gear ring on the axle, that is, turn it far and fix it.

        7. The entire width of the pressed brick blank is very large: if the eccentric axis cannot be maintained, change the new text; Correct the wedge iron of the shaft component to create a 0.5 gap between the square of the pressure bearing component and the Shanghai Composite Index.

        8. The top of the jar is severely damaged: repair the square at the bottom of the jar.

        9. Automatic truck wheel detachment and failure or excessive damage to the automatic locking neck: change its components.

        10. The cement brick machine production line suddenly stopped and got stuck. Due to excessive paraffin, the mold Mercoeur fell into a small knife. Repair method: Raise the nozzle while controlling the appropriate breadth of alginate or using a digestion knife.

        11. The narrow width of the pressed brick blank and improper lubricant may cause the slow speed disc to lower the thrust plate, resulting in heavy damage or improper adjustment of the eccentric shaft position of the cement fired brick making machine. Repair supporting measures: Improve the lubricant condition. If the push knife is severely damaged, it should be changed or replaced with a new eccentric shaft at a suitable low temperature by the end of the year.